WingHopper · Designer · Guide · Sections · Reef · Methods · Pricing · FAQ

Sections

Each station defines a foil section at a specific spanwise position. Sections blend smoothly between neighbours. Root and tip are anchors at 0% and 100% of the half-span; add stations between them to refine the spanwise foil distribution.

Choosing foils

The Sections page has the foil catalog: search it, and pin foils to overlay their shapes. Back in the designer, the Sections tab applies your pick along the span, or loads a .dat file of your own.

A .dat file loads as coordinates, which carry no polars. If catalog foils match its shape, WingHopper offers them, and they come with polars. If nothing matches, it can rebuild the file as a smooth curve that follows your points closely, which gives you a clean section to shape with; it still has no polars, because only a catalog foil carries those. You can always keep your coordinates as they are.

Invert sections

Flips every foil section upside-down (upper ↔ lower), which is how a stabilizer runs. Applies to the 3D view, the section preview, exports, and the flow solvers.

Check before using

Catalog polars describe a 2D section at their stated Reynolds and transition settings, not the whole wing. Changing geometry does not create new measured polars. XFOIL primer; wing polar.

Match a section from a mesh

Import a mesh from Library → Import mesh to replicate, or add it under Design → Reference. The existing Pro reference-model feature accepts STL, OBJ, GLB and self-contained glTF JSON. A glTF that depends on separate mesh/image files should be exported as one embedded GLB.

  1. Orient the mesh so its span runs along Z. Imports initially fit to a 1,000 mm longest edge; check the size instead of assuming the file's units were preserved. In Match a mesh section, enter a known size along the selected axis and click Set mesh size to calibrate the reference.
  2. Use Fit the wing to this model to replicate its planform. Section matching is a separate choice and does not change span, chord or twist.
  3. Open Match a mesh section, select a cut axis and position, then click Extract section. When the cut has several closed contours, choose the one to compare. Swap leading/trailing edge or flip vertically if needed.
  4. Compare the extracted polyline with the Kulfan fit and the ranked library sections. Select a destination wing station, then apply the polyline, the smooth fit, or a selected library section. Preview leaves the wing unchanged; Undo restores an applied section.

RMS and worst sampled-point deviations describe shape differences as fractions of chord. A close library match is not proof of the original airfoil's identity. Fitted sections have no measured polars; choosing a catalog section uses that entry's geometry and available polars.

Open or branching cuts are excluded rather than closed by guessing. Simplify meshes above 400,000 triangles or cuts above 10,000 vertices before fitting. This tool extracts planar section shapes; it does not reconstruct a whole CAD solid or automatically recover twist.

Next: Fluid, weight and ride speeds